CardInfo and QuickStart for ESP32

[VantagePro2]

Good evening!
I'm trying to connect SD shield to ESP32 by SPI:
MISO ->D19
MOSI->D23
SCK->D5
CS->D18
However, nothing happens after uploading the sketches CardInfo and QuickStart.
I used two different voltage supply - 3.3 and 5 V - for different shields.
But there aren't any information in Arduino IDE Monitor.
Why?

[greiman]

However, nothing happens after uploading the sketches CardInfo and QuickStart.

Is there no output from QuickStart? Do you see this?

Be sure to edit DISABLE_CHIP_SELECT if you have
a second SPI device. For example, with the Ethernet
shield, DISABLE_CHIP_SELECT should be set to 10
to disable the Ethernet controller.

SD chip select is the key hardware option.
Common values are:
Arduino Ethernet shield, pin 4
Sparkfun SD shield, pin 8
Adafruit SD shields and modules, pin 10

Enter the chip select pin number:

If you see this, what happens after entering a chip select pin number?

You should see something like this with error info.

Enter the chip select pin number: 10

Assuming the SD is the only SPI device.
Edit DISABLE_CHIP_SELECT to disable another device.

SD initialization failed.
Do not reformat the card!
Is the card correctly inserted?
Is chipSelect set to the correct value?
Does another SPI device need to be disabled?
Is there a wiring/soldering problem?

errorCode: 0x1, errorData: 0xff

[VantagePro2]

Yes,
I checked the different pins.
Also I used two different boards ESP32 and some SD shields (3.3 and 5 volts)
Unfortunately there wasn't any info in the monitor.
So I decided to ask you

[greiman]

I can't help since I don't have your hardware here and Serial.print does not work.

Try the BackwardCompatibility example. It is very simple.

[VantagePro2]

OK
Thanks for support